Пытаюсь настроить CacheXpress. Делаю всё по мануалу:The following will walk you through the configuring your Cisco router to use WCCP v2.
1. Log in to your router, and enter enable mode.
2. Enter "configure terminal" to enter configuration mode
3. Enter "no ip wccp web- cache" to disable any current WCCP configuration. If this command
produces an error, your router may not be capable of WCCPv2. Skip to the WCCPv1 section
below.
4. Enter "ip wccp version 2" to ensure the router is configured for WCCPv2.
5. Enter "ip wccp web- cache" to enable WCCP with the web- cache service.
6. If you wish to use a password for WCCP, enter "ip wccp web- cache password” (replace with
the password you actually wish to use).
7. A password is optional, but will increase security. Remember this password; you will need to
configure the cache later.
8. Determine which interface you will enable redirection on. This should be the interface that is
connected to the Internet (i.e. Serial 0/ 0).
9. Replace in the instructions below with this interface name.
10. Enter "interface” to configure this interface.
11. Enter "ip wccp web- cache redirect out".
12. Hit CTRL- Z to end configuration.В настройках CacheXpress указываю только версию протокола (2) и Router(s) (ip cisco).
Не указываю (что указывать и зачем?):Password, Redirect List, Telnet Password, Enable Password.
ISO у меня version 12.3
В итоге получаю:WCCP Cache-Engine information:
Web Cache ID: 192.168.1.4
Protocol Version: 2.0
State: NOT Usable
Initial Hash Info: 000500140000000200000001C0A80101
0000010F000000000008001800010004
Assigned Hash Info: 00000000000000000000000000000000
00000000000000000000000000000000
Hash Allotment: 0 (0.00%)
Packets Redirected: 0
Connect Time: 00:00:02Connect Time - всё время (минут через 5) обнуляется.
Что сделал не так/недоделал. Спасибо.P.S. в ISO я чайник :(
Немного не так, Connect Time обрывается секунд через 20-25.