URL: https://www.opennet.me/cgi-bin/openforum/vsluhboard.cgi
Форум: vsluhforumID6
Нить номер: 3547
[ Назад ]
Исходное сообщение
"Как протестировать модуль NM-HDA-4FXS"
Отправлено Gora , 26-Июл-03 14:08 
Есть Cisco 3661 в ней модуль NM-HDA-4FXS.
Порты на модуле не выдают сигнал (гудок) при снятии телефонной трубки.
Как можно протестировать работоспособность портов.
Cisco модуль "видит" порты настраиваются. При звонке на назначенный порту номер - сигнал занято.
Содержание
Сообщения в этом обсуждении
"Как протестировать модуль NM-HDA-4FXS"
Отправлено ВОЛКА , 26-Июл-03 20:38 
а настроили всё правильно?
"Как протестировать модуль NM-HDA-4FXS"
Отправлено Gora , 26-Июл-03 21:58 
voice-port 4/0/0
no vad
cptone RU
!
mgcp profile default
!
dial-peer cor custom
!
dial-peer voice 1 pots
huntstop
destination-pattern 1354489
port 4/0/0


d2-ms#sh voice port 4/0/0

Foreign Exchange Station 4/0/0 Slot is 4, Sub-unit is 0, Port is 0
Type of VoicePort is FXS
Operation State is DORMANT
Administrative State is UP
The Last Interface Down Failure Cause is Administrative Shutdown
Description is not set
Noise Regeneration is enabled
Non Linear Processing is enabled
Non Linear Mute is disabled
Non Linear Threshold is -21 dB
Music On Hold Threshold is Set to -38 dBm
In Gain is Set to 0 dB
Out Attenuation is Set to 3 dB
Echo Cancellation is enabled
Echo Cancellation NLP mute is disabled
Echo Cancellation NLP threshold is -21 dB
Echo Cancel Coverage is set to 8 ms
Playout-delay Mode is set to adaptive
Playout-delay Nominal is set to 60 ms
Playout-delay Maximum is set to 200 ms
Playout-delay Minimum mode is set to default, value 40 ms
Playout-delay Fax is set to 300 ms
Connection Mode is normal
Connection Number is not set
Initial Time Out is set to 10 s
Interdigit Time Out is set to 10 s
Call Disconnect Time Out is set to 60 s
Ringing Time Out is set to 180 s
Wait Release Time Out is set to 30 s
Companding Type is u-law
Region Tone is set for RU

Analog Info Follows:
Currently processing none
Maintenance Mode Set to None (not in mtc mode)
Number of signaling protocol errors are 0
Impedance is set to 600r Ohm
Station name None, Station number None
Translation profile (Incoming):
Translation profile (Outgoing):

Voice card specific Info Follows:
Signal Type is loopStart
Ring Frequency is 25 Hz
Hook Status is Trunked
Ring Active Status is inactive
Ring Ground Status is inactive
Tip Ground Status is inactive
Digit Duration Timing is set to 100 ms
InterDigit Duration Timing is set to 100 ms
No disconnect acknowledge
Ring Cadence is defined by CPTone Selection
Ring Cadence are [8 32] * 100 msec
Ringer Equivalence Number is set to 1