To compile this driver into the kernel, place the following lines in your
kernel configuration file:
device miibusdevice ae
Alternatively, to load the driver as a
module at boot time, place the following line in
loader.conf5:
if_ae_load="YES"
DESCRIPTION
The
device driver provides support for Attansic/Atheros L2 PCIe FastEthernet
controllers.
The controller supports hardware Ethernet checksum processing, hardware
VLAN tag stripping/insertion and an interrupt moderation mechanism.
Attansic L2 also features a 64-bit multicast hash filter.
The
driver supports the following media types:
autoselect
Enable autoselection of the media type and options.
The user can manually override the autoselected mode by
adding media options to
rc.conf5.
10baseT/UTP
Select 10Mbps operation.
100baseTX
Set 100Mbps (FastEthernet) operation.
The
driver provides support for the following media options:
full-duplex
Force full duplex operation.
half-duplex
Force half duplex operation.
For more information on configuring this device, see
ifconfig(8).
HARDWARE
The
driver supports Attansic/Atheros L2 PCIe FastEthernet controllers, and
is known to support the following hardware:
ASUS EeePC 701
ASUS EeePC 900
Other hardware may or may not work with this driver.
LOADER TUNABLES
Tunables can be set at the
loader(8)
prompt before booting the kernel or stored in
loader.conf5.
hw.ae.msi_disable
This tunable disables MSI support on the Ethernet hardware.
The default value is 0.
SYSCTL VARIABLES
The
driver collects a number of useful MAC counter during the work.
The statistics is available via the
dev.ae.%d.statssysctl(8)
tree, where %d corresponds to the controller number.
DIAGNOSTICS
"ae%d: watchdog timeout."
The device has stopped responding to the network, or there is a problem with
the network connection (cable).
"ae%d: reset timeout."
The card reset operation has been timed out.
"ae%d: Generating random ethernet address."
No valid ethernet address was found neither in the controller registers not in
NVRAM.
Random locally administered address with ASUS OUI identifier will be used
instead.
The Attansic L2 FastEthernet contoller supports DMA but do not use a descriptor
based transfer mechanism via scatter-gather DMA.
Thus the data should be copied to/from the controller memory on each
transmit/receive.
Furthermore, a lot of data alignment restrictions apply.
This may introduce a high CPU load on systems with heavy network activity.
Luckily enough this should not be a problem on modern hardware as L2 does
not support speeds faster than 100Mbps.
HISTORY
The
driver and this manual page was written by
An Stanislav Sedov
Aq [email protected] .
It first appeared in
Fx 7.1 .
