Интерактивная система просмотра системных руководств (man-ов)
asr (4)
>> asr (4) ( FreeBSD man: Специальные файлы /dev/* )
BSD mandoc
NAME
asr
- driver for Adaptec I2O based SCSI/ATA host bus adapters
SYNOPSIS
device asr
DESCRIPTION
The Adaptec
driver provides access to disks
and disk arrays controlled by I2O based host bus adapters and
SmartRAID SCSI RAID adapters through the standard SCSI disk
da(4)
interface.
The supported adapters provide 64 bit PCI,
Compact PCI, Zero Channel PCI,
and up to four channels of Ultra2, Ultra 160, or Ultra320 SCSI,
or two channels of 1GB Fibre.
All support RAID-0, RAID-1, RAID-10, RAID-5 and RAID-50 arrays.
All SCSI target types are supported.
For the ATA based controllers, one IDE drive per channel is supported.
Hot-swapping of IDE drives is not supported at this time.
All host bus adapters must be configured
before they can be used with any operating system.
Please contact Adaptec directly to obtain the latest information
on configuration utilities for the adapters.
Currently there are both a Motif based GUI configuration utility
and a CLI based configuration utility available from the Adaptec Web site.
The cards and arrays can also be configured via the BIOS based configuration
tool (SMOR).
HARDWARE
The adapters currently supported by the
driver include the following:
Adaptec SmartRAID PM3755U2B / SmartRAID V Millennium
Adaptec SmartRAID PM3757
DEC KZPCC-AC (LVD 1-ch, 4MB or 16MB cache),
DEC KZPCC-CE (LVD 3-ch, 64MB cache),
DEC KZPCC-XC (LVD 1-ch, 16MB cache),
DEC KZPCC-XE (LVD 3-ch, 64MB cache) -- rebadged SmartRAID V Millennium
FILES
/dev/asr*
Adaptec SCSI RAID control nodes
NOTES
The ATA based controllers present their devices as SCSI-like devices via CAM.
For IDE drives attached to these cards, a subset of standard SCSI commands
and mode pages are understood via translation performed in the card's firmware.
The
(Adaptec SCSI RAID)
driver first appeared as the dpti2o driver under BSDi
Bs x 3.2 ,
then under
Fx 2.2.8
and was ported over to the CAM layer represented in 4.0.
AUTHORS
An -nosplit
The
driver was kindly donated by Adaptec
and is maintained by
An Mark Salyzyn Aq [email protected] .
This manual page was written by
An Mark Salyzyn
and fixed up by
An Jeroen Ruigrok van der Werven Aq [email protected] .
