Date: Fri, 25 Oct 2002 12:19:23 +0300
From: Toni Lassila <toni.lassila@mc-europe.com.>
To: [email protected]Subject: IBM Infoprint Remote Management Simple DoS
Overview
=3D=3D=3D=3D=3D=3D=3D=3D
IBM makes a series of TCP/IP enabled printers that come with remote
management features:
<http://www.printers.ibm.com/R5PSC.NSF/Web/wglaserselect>;
One of these features is a Telnet-based remote management service, which
has a DoS vulnerability. The vulnerability discussed here was tested on =
an
IBM Infoprint 21 (older model), but is probably present in other =
printers
of the same product line.
Issue
=3D=3D=3D=3D=3D
The Telnet-enabled remote management feature used in the printer does =
not
properly check user input, namely the login name. By connecting to port =
23
and entering a login name consisting of an excessive number of =
characters
a DoS condition will occur, and the Telnet service will refuse to allow
further logins to the service. This is most likely due to a buffer
overflow vulnerability in the login handling code.
Power cycling the printer will restore functionality.
Impact
=3D=3D=3D=3D=3D=3D
After the DoS condition has occurred, the Telnet service on the printer
will continue accepting connections but will no longer display a login
prompt. The connection will eventually time out. Other services are
unaffected.=20
While testing with large input data I was able to bring the entire =
printer
down hard by sending enough data (several k) to port 23. The entire
network interface was down, and the physical control panel on the =
printer
was unresponsive. Printing was not possible. The only solution was to
power cycle the printer once or twice(!) to restore functionality.
Workaround
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
There do not appear to be any firmware updates available for the =
specific
printer, nor any mention of these kind of issues on the vendors web =
site.
Best practices dictate that printers and other internal assets should be
only accessible from the internal network or through authenticated
connections.
It does not seem to be possible to disable the Telnet service without
disabling all TCP/IP functionality from the printer.
Vendor Status
=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D=3D
IBM was contacted on 2002-10-18. No acknowledgement of response of any
kind was received.
