OpenForum RSS: HighErrorRate ��

HighErrorRate �� (starlets)

Wed, 11 Mar 2009 13:02:32 GMT

>�� (�2950) � �� (�3750) ��.
>�� giant(�� ).

tak nikto ne skazal shto oni ischeznut - esli u tebja est kakoj to protokol kotoryj ih generiruet - oni ne ischeznut. delo v tom - shto doljnyj otrabatyjvatsja normalno ...
esli hochesh znat pochemu oni pojavljautsja to sdelaj monitoring na port i posmotri wiresharkom shto tam vnutri :)
Ex: QinQ pass-through (802.1q inside 802.1q, useful for ISPs to segregate customer traffic)- 1526 bytes
MPLS VPN pass-through (two 4-byte labels)- 1526
UTI/L2TPV3 pass-through (encapsulate one Ethernet packet in another Ethernet packet with a tunneling header. Useful to transport any payload such as IP/IPX and so on over an IP backbone). - 1568 bytes
ja by prismotrelas v fakte shto eto na nechetnyh portah :)ochen intersno kakie protokoly prohodjat

HighErrorRate �� (Babaich)

Tue, 10 Mar 2009 08:53:04 GMT

>� �� ӣ ��?

�� . �� . �� . � �� -�� .

Port Single-Col Multi-Col Late-Col Excess-Col Carri-Sen Runts Giants
Gi1/1 0 0 0 0 0 0 64714
Gi1/2 0 0 0 0 0 0 0
Gi1/3 0 0 0 0 0 0 31852
Gi1/4 0 0 0 0 0 0 0
Gi1/5 0 0 0 0 0 0 50124
Gi1/6 0 0 0 0 0 0 0
Gi1/7 0 0 0 0 0 0 78641
Gi1/8 0 0 0 0 0 0 0
Gi1/9 0 0 0 0 0 0 10717
Gi1/10 0 0 0 0

HighErrorRate �� (��)

Tue, 10 Mar 2009 07:56:18 GMT

� �� ӣ ��?

HighErrorRate �� (Babaich)

Tue, 10 Mar 2009 07:36:09 GMT

>[�� ]
>>�� , �� , �� ?
>>
>>��.
>
>http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.1E/native/configuration/guide/sw_int.html#wp1041111
>https://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_example09186a008010edab.shtml#c1
>
>"Configure Native IOS
> 7609(config)#int gigabitEthernet 1/1
> 7609(config-if)#mtu 9216"

�� MTU 9216, �� . Giant-�� 15-20% ��.

CORE1#sh int po2
Port-channel2 is up, line protocol is up (connected)
Hardware is EtherChannel, address is 0015.c62b.eddc (bia 0015.c62b.eddc)
Description: Link to C3750_1
MTU 9216 bytes, BW 2000000 Kbit, DLY 10 usec,
reliability 255/255, txload 2/255, rxload 7/255
Encapsulation ARPA, loopback not set
Full-duplex, 1000Mb/s
input flow-control is off, output flow-control is unsupported
Members in this channel: Gi1/33 Gi1/35
ARP type: ARPA, ARP Timeout 04

HighErrorRate �� (starlets)

Mon, 09 Mar 2009 20:35:38 GMT

>[�� ]
> 0 babbles, 0 late collision, 0 deferred
>
> 0 lost carrier, 0 no carrier
> 0 output buffer failures, 0 output buffers
>swapped out
>
>�� -�� giants-��?
>�� , �� , �� ?
>
>��.

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.1E/native/configuration/guide/sw_int.html#wp1041111
https://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_example09186a008010edab.shtml#c1

"Configure Native IOS
7609(config)#int gigabitEthernet 1/1
7609(config-if)#mtu 9216"

OpenForum RSS: HighErrorRate �� �����������

HighErrorRate �� ����������� (starlets)

HighErrorRate �� ����������� (Babaich)

HighErrorRate �� ����������� (���)

HighErrorRate �� ����������� (Babaich)

HighErrorRate �� ����������� (starlets)

OpenForum RSS: HighErrorRate ��

HighErrorRate �� (starlets)

HighErrorRate �� (Babaich)

HighErrorRate �� (��)

HighErrorRate �� (Babaich)

HighErrorRate �� (starlets)