Никак не могу настроить общение Vlan'ов между Cisco'й 2960 и Роутером MikroTik Rb751. Мне нужно пробросить Vlan 1,3 на MiKrotik на разные порты. С цискки микротик пока не видно. Что пошло не так не понимаю.

#################Настройки Cisco.###############
[q]Switch#show vlan

VLAN Name                             Status    Ports
---- -------------------------------- --------- -------------------------------
1    default                          active    Fa0/1, Fa0/2, Fa0/3, Fa0/4
                                                Fa0/5, Fa0/6, Fa0/7, Fa0/8
                                                Fa0/9, Fa0/10, Fa0/11, Fa0/12
                                                Fa0/13, Fa0/14, Fa0/15, Fa0/16
                                                Fa0/17, Fa0/18, Fa0/19, Fa0/20
                                                Fa0/21, Fa0/22, Fa0/23, Fa0/24
                                                Fa0/25, Fa0/26, Fa0/27, Fa0/28
                                                Fa0/29, Fa0/30, Fa0/31, Fa0/33
                                                Fa0/34, Fa0/35, Fa0/41, Fa0/44
                                                Fa0/45, Gi0/1, Gi0/2
2    VLAN0002                         active    Fa0/37, Fa0/38, Fa0/39, Fa0/40
3    VLAN0003                         active
4    VLAN0004                         active    Fa0/48
[/q]
#####
Switch#configure t
Switch(config)#interface fastEthernet 0/43
Switch(config-if)#switchport mode trunk
Switch(config-if)#switchport trunk allowed vlan 1,3
Switch(config-if)#exit

#основаная сеть а дефолтном 1 вилане в который и хочу выпустить 1 порт микротика#

###################### Настройка MikroTik'a: ############################

#Созданы два Vlan#

[admin@MikroTik] > interface print
Flags: D - dynamic, X - disabled, R - running, S - slave
#     NAME                               TYPE               MTU L2MTU  MAX-L2MTU
0  R  ether1-gateway                     ether             1500  1600       4076
1  R  ether2-master-local                ether             1500  1598       2028
2     ether3-slave-local                 ether             1500  1598       2028
3     ether4-slave-local                 ether             1500  1598       2028
4     ether5-slave-local                 ether             1500  1598       2028
5     wlan1                              wlan              1500  2290
6  R  bridge-local                       bridge            1500  1598
7  R  Pilot                              vlan              1500  1596
8  R  Video                              vlan              1500  1596
9  R  Pilot_br                           bridge            1500  1596
10  R  video_br                           bridge            1500  1596
11  R  eth5_pilot                         bridge            1500 65535

[admin@MikroTik] > interface vlan print
Flags: X - disabled, R - running, S - slave
#    NAME                          MTU ARP        VLAN-ID INTERFACE                      
0 R  Pilot                        1500 enabled          1 ether1-gateway                  
1 R  Video                        1500 enabled          3 ether1-gateway

#Обоим присвоены адреса адресация в Vlan правильная#

[admin@MikroTik] > ip address print
Flags: X - disabled, I - invalid, D - dynamic
#   ADDRESS            NETWORK         INTERFACE                                
0   ;;; default configuration
     192.168.88.1/24    192.168.88.0    wlan1                                    
1   192.168.10.14/24   192.168.10.0    Pilot                                    
2   192.168.1.14/24    192.168.1.0     Video

#Добавлены бриджи#

[admin@MikroTik] > interface bridge print
Flags: X - disabled, R - running
0  R name="bridge-local" mtu=1500 l2mtu=1598 arp=enabled
      mac-address=D4:CA:6D:A6:03:97 protocol-mode=rstp priority=0x8000
      auto-mac=no admin-mac=D4:CA:6D:A6:03:97 max-message-age=20s
      forward-delay=15s transmit-hold-count=6 ageing-time=5m

1  R name="Pilot_br" mtu=1500 l2mtu=1596 arp=enabled
      mac-address=D4:CA:6D:A6:03:96 protocol-mode=none priority=0x8000
      auto-mac=yes admin-mac=00:00:00:00:00:00 max-message-age=20s
      forward-delay=15s transmit-hold-count=6 ageing-time=5m

2  R name="video_br" mtu=1500 l2mtu=1596 arp=enabled
      mac-address=D4:CA:6D:A6:03:96 protocol-mode=none priority=0x8000
      auto-mac=yes admin-mac=00:00:00:00:00:00 max-message-age=20s
      forward-delay=15s transmit-hold-count=6 ageing-time=5m

3  R name="eth5_pilot" mtu=1500 l2mtu=65535 arp=enabled
      mac-address=00:00:00:00:00:00 protocol-mode=none priority=0x8000
      auto-mac=yes admin-mac=00:00:00:00:00:00 max-message-age=20s
      forward-delay=15s transmit-hold-count=6 ageing-time=5m

#Порты бриджей. Тут дополнительно пытаюсь прокинуть Vlan1(в циске он так зовётся) на 5 апорт микротика тут vlan зовётся Pilot#

[admin@MikroTik] > interface bridge port print
Flags: X - disabled, I - inactive, D - dynamic
#    INTERFACE              BRIDGE              PRIORITY  PATH-COST    HORIZON
0    ether2-master-local    bridge-local            0x80         10       none
1 I  wlan1                  bridge-local            0x80         10       none
2    ether1-gateway         bridge-local            0x80         10       none
3    Pilot                  Pilot_br                0x80         10       none
4    Video                  video_br                0x80         10       none
5 I  ether5-slave-local     Pilot_br                0x80         10       nonе