The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]



"Проблема с Cat6k-Sup720/SP"
Версия для распечатки Пред. тема | След. тема
Форум Маршрутизаторы CISCO и др. оборудование.
Исходное сообщение [ Отслеживать ]

"Проблема с Cat6k-Sup720/SP" +/
Сообщение от Dimasikm (ok), 14-Май-15, 15:45 
Всех гуру приветствую, столкнулся с проблемой не загружается этот зверь.
Сразу оговорюсь с Cisco вообще дел не имел, пришлось)
после включения выпадает в rommon. При загрузке пишет следующее:
System Bootstrap, Version 8.5(4)
Copyright (c) 1994-2009 by cisco Systems, Inc.

Warning: Rommon NVRAM area is corrupted. Initialize the area to default values
Cat6k-Sup720/SP processor with 1048576 Kbytes of main memory

Autoboot: failed, BOOT string is empty
Autoboot executing command: "boot "
device does not contain a valid magic number
boot: cannot open "bootdisk:"
boot: cannot determine first file name on device "bootdisk:"

System Bootstrap, Version 8.5(4)
Copyright (c) 1994-2009 by cisco Systems, Inc.
Cat6k-Sup720/SP processor with 1048576 Kbytes of main memory

Autoboot executing command: "boot bootdisk:"
device does not contain a valid magic number
boot: cannot open "bootdisk:"
boot: cannot determine first file name on device "bootdisk:"

System Bootstrap, Version 8.5(4)
Copyright (c) 1994-2009 by cisco Systems, Inc.
Cat6k-Sup720/SP processor with 1048576 Kbytes of main memory
-----------------------------
rommon 1 > set
PS1=rommon ! >
rommon 2 > dev
Devices in device table:
        id  name
bootdisk:  boot disk
    disk0:  PCMCIA Disk 0
    disk1:  PCMCIA Disk 1
    eprom:  eprom
      usb:  USB
rommon 3 > dir bootdisk:
device does not contain a valid magic number
dir: cannot open device "bootdisk:"
rommon 4 > dir disk0:
PCMCIA disk0: device is not initialized
open: read error...requested 0x4 bytes, got 0x0
trouble reading device magic number
dir: cannot open device "disk0:"
rommon 5 > dir disk1:
PCMCIA disk1: device is not initialized
open: read error...requested 0x4 bytes, got 0x0
trouble reading device magic number
dir: cannot open device "disk1:"
rommon 6 >
------------------------------------------
Посоветуйте куда копать и что делать? я так понимаю не загружается IOS. Пытался залить IOS через xmodem, ждал больше 7 часов, и ничего не произошло. ключ у команды xmodem только один:

rommon 6 > xmodem
usage: xmodem [-s]
-s<speed> Set speed of download, where speed may be
          4800|9600|19200|38400|57600
rommon 7 >
------------------------------------------

Ответить | Правка | Cообщить модератору

Оглавление
Проблема с Cat6k-Sup720/SP, Dimasikm, 14-Май-15, 15:45  [смотреть все]
Форумы | Темы | Пред. тема | След. тема



Партнёры:
PostgresPro
Inferno Solutions
Hosting by Hoster.ru
Хостинг:

Закладки на сайте
Проследить за страницей
Created 1996-2024 by Maxim Chirkov
Добавить, Поддержать, Вебмастеру