Партнёры:
Хостинг:
pkcs11_inspect - print certificate contents
/usr/lib/pam_pkcs11/pkcs11_inspect [debug] [config_file=filename]
pkcs11_inspect uses the pam_pkcs11 library infrastructure to obtain the content of a certificate and display it.
pkcs11_inspect uses the same configuration file and arguments as the pam_pkcs11(5) PAM module. It loads defined mapper modules, and uses them to look into the certificate for required entries, that is, ms_mapper looks for ms UPN entries, and so forth.
When a mapper module finds a proper entry in the certificate, it converts to UTF-8 and prints it to stdout.
The following options are supported:
config_file=fileame
debug
As it uses the same configuration file as pam_pkcs11(5), all of the pam_pkcs11 options are available. Some of these options make no sense in a non-PAM environment, and are therefore ignored. Some mapper options (mapfile, ignorecase) have no effect on certificate contents, and they are ignored as well.
The following exit values are returned:
0
pkcs11_inspect prints on stdout all certificate contents that are found for mappers.
1
Example 1 Using pkcs_inspect
The following example runs the pkcs_inspect command without any options:
% pkcs11_inspect
Example 2 Using pkcs_inspect with Options
The following example runs the pkcs_inspect command with options:
% pkcs11_inspect debug config_file=${HOME}/.pam_pkcs11.conf
/etc/security/pam_pkcs11/pam_pkcs11.conf
Juan Antonio Martinez, [email protected]
See attributes(5) for descriptions of the following attributes:
| |||||||||
pklogin_finder(1), attributes(5), pam_pkcs11(5)
PAM-PKCS11 User Manual, http://www.opensc-project.org/pam_pkcs11
|
Закладки на сайте Проследить за страницей |
Created 1996-2024 by Maxim Chirkov Добавить, Поддержать, Вебмастеру |