The
utility attaches the ISO-9660 file system residing on the device
special
to the global file system namespace at the location indicated by
node
This command is normally executed by
mount(8)
at boot time.
The options are as follows:
-b
Relax checking for Supplementary Volume Descriptor Flags field
which is set to a wrong value on some Joliet formatted disks.
-e
Enable the use of extended attributes.
-g
Do not strip version numbers on files.
(By default, if there are files with different version numbers on the disk,
only the last one will be listed.)
In either case, files may be opened without explicitly stating a
version number.
-j
Do not use any Joliet extensions included in the file system.
-o
Options are specified with a
-o
flag followed by a comma separated string of options.
See the
mount(8)
man page for possible options and their meanings.
The following cd9660 specific options are available:
extatt
Same as
-e
gens
Same as
-g
nojoliet
Same as
-j
norrip
Same as
-r
nostrictjoliet
Same as
-b
-r
Do not use any Rockridge extensions included in the file system.
-s startsector
Start the file system at
startsector
Normally, if the underlying device is a CD-ROM drive,
will try to figure out the last track from the CD-ROM containing
data, and start the file system there.
If the device is not a CD-ROM,
or the table of contents cannot be examined, the file system will be
started at sector 0.
This option can be used to override the behaviour.
Note that
startsector
is measured in CD-ROM blocks, with 2048 bytes each.
This is the same
as for example the
info
command of
cdcontrol(1)
is printing.
It is possible to mount an arbitrary session of a multi-session CD by specifying
the correct
startsector
here.
-C charset
Specify local
charset
to convert Unicode file names when using Joliet extensions.
-v
Be verbose about the starting sector decisions made.
EXAMPLES
The following command can be used to mount a Kodak Photo-CD:
The Unicode conversion routine was added by
An Ryuichiro Imura Aq [email protected]
in 2003.
BUGS
POSIX device node mapping is currently not supported.
Version numbers are not stripped if Rockridge extensions are in use.
In this case, accessing files that do not have Rockridge names without
version numbers gets the one with the lowest version number and not
the one with the highest.
