>>ошибка: sbc ни в какие ворота для Yamaha - man 4 sbc
>>
>
>Цитирую handbook. (карты на OPL-Sax по большей части PCI'ные)
>
>Before you begin, you should know the model of the card you
>have, the chip it uses, and whether it is a PCI
>or ISA card. FreeBSD supports a wide variety of both PCI
>and ISA cards. If you do not see your card in
>the following list, check the pcm(4) manual page. This is not
>a complete list; however, it does list some of the most
>common cards.
>
>. . .
>Yamaha OPL-SAx
>. . .
>
>[-- skip --]
>
>If you have one of the above cards, you will need to
>add:
>
> device pcm
>
>to your kernel configuration file. If you have a PnP ISA card,
>
>you will also need to add:
>^^^^^^^^^^^^^^^^^^^^^^^^^^
> device sbc
>
>For a non-PnP ISA card, add:
>
> device pcm
> device sbc0 at isa? port 0x220 irq 5
>drq 1 flags 0x15
>
>to your kernel configuration file. The settings shown above are the defaults.
>You may need to change the IRQ or the other settings
>to match your card. See the sbc(4) manual page for more
>information.
блин, еще раз:
man 4 sbc:
SBC(4) FreeBSD Kernel Interfaces Manual SBC(4)
NAME
sbc - Creative Sound Blaster ISA and compatible bridge device driver
SYNOPSIS
For PnP cards:
device sbc
For non-PnP cards:
device sbc0 at isa? port 0x220 irq 5 drq 1 flags 0x15
DESCRIPTION
The sbc bridge driver allows the generic audio drivers including pcm(4)
to attach to the following ISA sound cards:
o Creative SB16, SB32, SB AWE64 (including Gold) and ViBRA16
o Advance Asound 100, 110 and Logic ALS120
o ESS ES1868, ES1869, ES1879 and ES1888
The value of flags specifies the secondary DMA channel. If the secondary
DMA channel is C, set the flags to (C | 0x10). For a sound card without
the secondary DMA channel, the flags should be set to zero.
DIAGNOSTICS
теперь смотрим man 4 sb:
SB(4) FreeBSD/i386 Kernel Interfaces Manual SB(4)
NAME
sb - Creative Labs Sound Blaster and compatible device driver
SYNOPSIS
For all sound cards supported with the sb driver this is needed:
device snd0
For the SoundBlaster, SB Pro, SoundBlaster16, or the Pro Audio Spectrum
(emulating SB):
device sb0 at isa? port 0x220 irq 7 drq 1
For specific SB16 support:
device sbxvi0 at isa? drq 5
For SoundBlaster 16 16 bit MIDI support:
device sbmidi0 at isa? port 0x300
To add Jazz16 suport:
options JAZZ16
To add support for the Logitech SoundMan Games:
options SM_GAMES
To add SG NX Pro mixer support:
options __SGNXPRO__
The OPL-2/3 is used in the SoundBlaster, SoundBlaster Pro, SB 16, and the
Pro Audio Spectrum. For Yamaha OPL-2/OPL-3 FM support:
device opl0 at isa? port 0x388
DESCRIPTION
смотрим LINT:
# Audio drivers: `snd', `sb', `pas', `gus', `pca'
#
# snd: Voxware sound support code
# sb: SoundBlaster PCM - SoundBlaster, SB Pro, SB16, ProAudioSpectrum
# sbxvi: SoundBlaster 16
# sbmidi: SoundBlaster 16 MIDI interface
# pas: ProAudioSpectrum PCM and MIDI
# gus: Gravis Ultrasound - Ultrasound, Ultrasound 16, Ultrasound MAX
# gusxvi: Gravis Ultrasound 16-bit PCM (do not use)
# mss: Microsoft Sound System
# css: Crystal Sound System (CSS 423x PnP)
# sscape: Ensoniq Soundscape MIDI interface
# sscape_mss: Ensoniq Soundscape PCM (requires sscape)
# opl: Yamaha OPL-2 and OPL-3 FM - SB, SB Pro, SB 16, ProAudioSpectrum
# uart: stand-alone 6850 UART for MIDI
# mpu: Roland MPU-401 stand-alone card
#
# Note: It has been reported that ISA DMA with the SoundBlaster will
# lock up the machine (PR docs/5358). If this happens to you,
# turning off USWC write posting in your machine's BIOS may fix
# the problem.
#
# Beware! The addresses specified below are also hard-coded in
# src/sys/i386/isa/sound/sound_config.h. If you change the values here, you
# must also change the values in the include file.
#
# pcm: PCM audio through various sound cards.
#
отсюда, если PNP:
device pcm
non-PNP:
device pcm0 at isa? irq XY drq Z flags 0xAB
выше указать правильный IRQ, DMA и опустить или указать flags
и добавить:
options PNPBIOS
в самом BIOS выставить PNP OS: Disable или PNP OS: BIOS
PS. Может быть я мало карт имел, но не видел Ямах Creative Compatible
Все.
Вариант для распечатки
OpenNET: Виртуальная конференция (Public)
on
23-Июн-02, 20:44 (MSK)
