>Здарсе всем!
>
>Подскажите пожалуйста, где в ЛИНУХЕ прописать, чтоб при запросе соединения по VPN,
>он отпралял авторизироваться на РАДИУС серве?
>
>Имется VPN на fedora 3, pptpd-1.2.3-1, ppp-2.4.3, mppe-128
>и РАДИУС сервер на Windows 2003 Srv
В ppp.conf.sample очень внятно расписано:
# When the peer authenticates itself, we use ppp.secret for verification
# (although refer to the ``set radius'' command below for an alternative).
#
# Note: We may supply a third field in ppp.secret specifying the IP
# address for that user, a fourth field to specify the
# ppp.link{up,down} label to use and a fifth field to specify
# callback characteristics.
#
# The easiest way to allow transparent LAN access to your dialin users
# is to assign them a number from your local LAN and tell ppp to make a
# ``proxy'' arp entry for them. In this example, we have a local LAN
# with IP numbers 10.0.0.1 - 10.0.0.99, and we assign numbers to our
# ppp clients between 10.0.0.100 and 10.0.0.199. It is possible to
# override the dynamic IP number with a static IP number specified in
# ppp.secret.
#
# Ppp is launched with:
# # ppp -direct server
#
server:
enable chap chap80 chap81 pap passwdauth
enable proxy
set ifaddr 10.0.0.1 10.0.0.100-10.0.0.199
accept dns
# Example of a RADIUS configuration:
# If there are one or more radius servers available, we can use them
# instead of the ppp.secret file. Simply put then in a radius
# configuration file (usually /etc/radius.conf) and give ppp the
# file name.
# Ppp will use the FRAMED characteristics supplied by the radius server
# to configure the link.
radius-server:
load server # load in the server config from above
set radius /etc/radius.conf
Вариант для распечатки
OpenNET: Виртуальная конференция (Public)
(ok) on
26-Окт-05, 09:38 (MSK)
