Не пускет и всё тут... Лог:

[pptp0:pptp0] mpd: PPTP connection from ххх.ххх.ххх.ххх:1843
pptp0: attached to connection with ххх.ххх.ххх.ххх:1843
[pptp0] IFACE: Open event
[pptp0] IPCP: Open event
[pptp0] IPCP: state change Initial --> Starting
[pptp0] IPCP: LayerStart
[pptp0] IPCP: Open event
[pptp0] bundle: OPEN event in state CLOSED
[pptp0] opening link "pptp0"...
[pptp0] link: OPEN event
[pptp0] LCP: Open event
[pptp0] LCP: state change Initial --> Starting
[pptp0] LCP: LayerStart
[pptp0] device: OPEN event in state DOWN
[pptp0] attaching to peer's outgoing call
[pptp0] device is now in state OPENING
[pptp0] device: UP event in state OPENING
[pptp0] device is now in state UP
[pptp0] link: UP event
[pptp0] link: origination is remote
[pptp0] LCP: Up event
[pptp0] LCP: state change Starting --> Req-Sent
[pptp0] LCP: phase shift DEAD --> ESTABLISH
[pptp0] LCP: SendConfigReq #17
ACFCOMP
PROTOCOMP
MRU 1500
MAGICNUM c8612560
AUTHPROTO CHAP MSOFTv2
MP MRRU 1600
MP SHORTSEQ
ENDPOINTDISC [802.1] 00 60 08 c5 fc ed
pptp0-0: ignoring SetLinkInfo
[pptp0] LCP: SendConfigReq #18
ACFCOMP
PROTOCOMP
MRU 1500
MAGICNUM c8612560
AUTHPROTO CHAP MSOFTv2
MP MRRU 1600
MP SHORTSEQ
ENDPOINTDISC [802.1] 00 60 08 c5 fc ed
[pptp0] LCP: SendConfigReq #19
ACFCOMP
PROTOCOMP
MRU 1500
MAGICNUM c8612560
AUTHPROTO CHAP MSOFTv2
MP MRRU 1600
MP SHORTSEQ
ENDPOINTDISC [802.1] 00 60 08 c5 fc ed
pptp0-0: ignoring SetLinkInfo

далее рвет соединение и все...

Настройка:
# cat mpd.conf
default:
        load pptp0

pptp0:
        new -i ng0 pptp0 pptp0
        set ipcp ranges 10.1.4.1/30 10.1.5.1/30
        load pptp_standart

pptp_standart:
   set iface disable on-demand
   set bundle enable multilink
   set link yes acfcomp protocomp
   set link no pap chap
   set link enable chap
   set link keep-alive 60 180
   set ipcp yes vjcomp
   set ipcp dns 172.16.0.1
   set pptp enable incoming
   set pptp disable originate
   set iface mtu 1500
   set link mtu 1500
   set radius server localhost secret 1812 1813
   set radius timeout 10
   set radius config /etc/radius.conf
   set radius retries 3
   set bundle enable radius-acct
   set bundle enable radius-auth
   set ipcp yes radius-ip

Отцы! Куда рыть, подскажите!

• Снова MPD! HELP!, Chris, 12:47 , 23-Дек-05, (1)