Опять банальная проблема...
Схема подключения
АТС (Ericsson AEX-10) ----> Modem Tainet 1300 (G.703) -- 2Mб--> Modem Tainet 1300 (G.703)----> Cisco 3725.
---
Натройки на модемах . Framing., Framing no crc. Да и еще Когда ставишь Unframing Модемы вяжутся и ошибок нет никаких, но ISDN Layer 1 Мертвый. В режиме Framing ISDN Layer 1 UP но...
ISDN Serial2/0:15 interface
******* Network side configuration *******
dsl 0, interface ISDN Switchtype = primary-net5
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = AWAITING_ESTABLISHMENT
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0x7FFF7FFF
Number of L2 Discards = 0, L2 Session ID = 132
Total Allocated ISDN CCBs = 0
---
Насторойки маршрутизатора
Building configuration...
Current configuration : 4819 bytes
!
version 12.3
service timestamps debug datetime msec
service timestamps log datetime msec
card type e1 2
isdn switch-type primary-net5
isdn voice-call-failure 0
!
controller E1 2/0
framing NO-CRC4
pri-group timeslots 1-31
!
interface Serial2/0:15
no ip address
encapsulation ppp
ip mroute-cache
dialer rotary-group 1
dialer-group 1
isdn switch-type primary-net5
isdn overlap-receiving
isdn not-end-to-end 64
isdn protocol-emulate network (Пробовал и User)
isdn incoming-voice modem
isdn send-alerting
!
interface Group-Async1
ip unnumbered FastEthernet0/0
encapsulation ppp
ip tcp header-compression
load-interval 30
async dynamic routing
async mode interactive
peer default ip address pool default
ppp authentication chap pap
group-range 33 62
!
3725#sh interfaces serial 2/0:15
Serial2/0:15 is up, line protocol is up (spoofing)
Hardware is M32X with CSU/DSU
MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 1 seconds on reset
Last input never, output 00:00:03, output hang never
Last clearing of "show interface" counters 19:38:25
Input queue: 0/75/59/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 48 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 5 runts, 0 giants, 0 throttles
73 input errors, 14 CRC, 47 frame, 0 overrun, 0 ignored, 33 abort
31416 packets output, 94248 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
1 carrier transitions
Timeslot(s) Used:16, Transmitter delay is 0 flags
3725#sh controllers e1
E1 2/0 is up.
Applique type is Channelized E1 - balanced
Description: E1 # 2516109
No alarms detected.
alarm-trigger is not set
Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.
Module type is Channelized E1/T1 PRI
Version info Firmware: 0000001D, FPGA: 0
Hardware revision is 0.0 , Software revision is 29
Protocol revision is 1
number of CLI resets is 0
receive remote alarm : 0,
transmit remote alarm : 0,
receive AIS alarm : 1,
transmit AIS alarm : 0,
loss of frame : 1,
loss of signal : 0,
Loopback test : 0,
transmit AIS in TS 16 : 0,
receive LOMF alarm : 0,
transmit LOMF alarm : 0,
MIB data updated every 10 seconds.
Data in current interval (546 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 78 15 minute intervals):
1 Line Code Violations, 133 Path Code Violations,
0 Slip Secs, 1 Fr Loss Secs, 1 Line Err Secs, 0 Degraded Mins,
2 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 14 Unavail Secs
У кого есть мысли в чем беда? Прошу поделится !