День добрый!
Имею (sh version): Cisco IOS Software, 2800 Software (C2800NM-ADVIPSERVICESK9-M), Version 12.4(22)T5, RELEASE SOFTWARE (fc3)
!!!
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
!!!
System returned to ROM by reload at 22:18:09 GMT Fri Jan 10 2014
System restarted at 22:20:16 GMT Fri Jan 10 2014
System image file is "flash:c2800nm-advipservicesk9-mz.124-22.T5.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
Cisco 2821 (revision 53.50) with 241664K/20480K bytes of memory.
Processor board ID FCZ124770BW
2 Gigabit Ethernet interfaces
1 ATM interface
1 terminal line
1 Virtual Private Network (VPN) Module
1 cisco Special Services Engine(s)
NME-RVPN in slot 1
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62720K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
ПРОБЛЕМА: Настроен интерфейс:
!
interface ATM0/3/0.1 point-to-point
description net.ISP
ip address х.х.х.х х.х.х.х
no ip redirects
no ip proxy-arp
ip mtu 1508
ip flow monitor pingmon input
ip flow ingress
ip flow egress
ip authentication mode eigrp 65525 md5
ip authentication key-chain eigrp 65525 EIGRPCHAIN
ip pim sparse-dense-mode
ip virtual-reassembly
atm route-bridged ip
mpls mtu 1508
mpls ldp discovery transport-address х.х.х.х
mpls label protocol both
mpls ip
pvc 0/36
vbr-rt 2047 2047 1
tx-ring-limit 3
encapsulation aal5snap
service-policy input mpls2ip_MPLSEXP-QG-DC-MAPPING
service-policy output ip2mpls_CBWF-QUEUNING-WRED
pppoe-client dial-pool-number 81
pppoe-client dial-pool-number 80
pppoe-client dial-pool-number 21
pppoe-client dial-pool-number 20
!
ТАК ВОТ СТРОКА "service-policy output ip2mpls_CBWF-QUEUNING-WRED" бесследно через некоторое время исчезает, в стартапе присутствует, но даже оттуда не загружается в ран. Иногда после танцев с бубном (например добавить строку-записать) появляется, но потом опять исчезает. Читала, что помогает обновление (вот интересно - на какую версию надо обновить?). Кто что посоветует? Спасибо!
Вариант для распечатки
