Есть циска 2821 в нее воткнуты два виковских модуля hwic-4eswCisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(3b), RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Fri 09-Dec-05 10:52 by alnguyen
ROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)
PolarStar2800 uptime is 3 hours, 23 minutes
System returned to ROM by power-on
System image file is "flash:c2800nm-ipbase-mz.124-3b.bin"
Cisco 2821 (revision 53.51) with 249856K/12288K bytes of memory.
Processor board ID FCZ1003702P
8 FastEthernet interfaces
2 Gigabit Ethernet interfaces
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62592K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
делаю
interface Vlan165
ip address 192.168.62.253 255.255.255.252
включаю его в vlan database
далее
interface FastEthernet0/0/3
switchport access vlan 165
подключаю через кросовер ноутбук, пинги ходят.
interface FastEthernet0/0/3
no switchport access vlan 165
убираю вилан с первого модуля и после
interface FastEthernet0/2/3
switchport access vlan 165
включаю ноутбук на третий порт второго модуля, пинги не ходят, в тоже время
sh interface FastEthernet0/2/3
FastEthernet0/2/3 is up, line protocol is up
и
sh arp
Protocol Address Age (min) Hardware Addr Type Interface
Internet 192.168.62.65 - 0016.4610.bfb8 ARPA Vlan399
Internet 192.168.62.74 30 0030.4f4c.2138 ARPA Vlan399
Internet 192.168.63.74 - 0016.4610.bfb8 ARPA Vlan102
Internet 192.168.63.73 207 000f.8fcf.2892 ARPA Vlan102
Internet 194.84.206.17 - 0016.4610.bfb8 ARPA GigabitEthernet0/0
Internet 194.84.206.19 0 0005.5ea1.ab90 ARPA GigabitEthernet0/0
Internet 192.168.0.233 207 0010.7b31.b501 ARPA GigabitEthernet0/1
Internet 192.168.0.234 - 0016.4610.bfb9 ARPA GigabitEthernet0/1
Internet 192.168.62.254 136 000a.e45a.db88 ARPA Vlan165
Internet 192.168.62.253 - 0016.4610.bfb8 ARPA Vlan165
т.е. циска видит ноутбук, в чем засада?