Доброго времени суток всем, нуждаюсь в помощи по настройке вещания на оборудовании из сабжа... Собственно в качестве источника стоит EMR, из него в Catalyst 3750x, из него в DLink 1210-28 и далее в сеть... На данном этапе настроено вещание лишь одного ТВ канала, для пробы, сеть и порт источника в разных вланах, далее прописано:
ip igmp snooping vlan 1 mrouter interface Gi1/0/10
ip igmp snooping vlan 10
ip igmp profile 10
permit
range 224.10.10.10 224.10.10.10
и на интерфейсе Gi1/0/5 - он смотрит на DLink!
interface GigabitEthernet1/0/10
switchport access vlan 10
switchport mode access
snmp trap mac-notification change added
snmp trap mac-notification change removed
spanning-tree port-priority 0
ip igmp filter 10
vlan 1 это сеть, vlan 10 и Gi1/0/10 это соответственно источник, 224.10.10.10 группа которую для теста вещаю.
Pim не включал, так как пока не понимаю как он работает на данном девайсе, тут доступен лишь режим ip pim passive... Собственно на тестовой машинке картинка есть, нареканий пока что нет, есть несколько вопросов:
1. В целом интересует почему резко возрастает нагрузка на цпу как только включаю snooping на первом влане, при чем нагрузка скачет наверное каждые 2 секунды, то резко падает, то резко подлетает вверх
c3750x#sh proc cpu s
CPU utilization for five seconds: 45%/1%; one minute: 58%; five minutes: 62%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
301 8725443 3063054 2848 27.20% 40.18% 43.54% 0 IGMPSN
172 17440487 27600636 631 4.48% 3.87% 3.74% 0 Hulc LED Process
125 32473926 54238746 598 3.68% 2.78% 2.64% 0 hpm main process
219 7093743 39492161 179 1.75% 1.69% 1.70% 0 IP Input
85 1383455 3709795 372 0.47% 0.15% 0.14% 0 RedEarth I2C dri
86 3217423 3195688 1006 0.31% 0.28% 0.32% 0 RedEarth Tx Mana
129 1920164 1113314 1724 0.31% 0.25% 0.26% 0 hpm counter proc
325 486176 34644523 14 0.15% 0.04% 0.00% 0 MMON MENG
352 22446 206027 108 0.15% 0.13% 0.08% 0 PIM Process
178 96535 112422 858 0.15% 0.91% 1.06% 0 IGMP Input
Часто нагрузка составляет 80%. Это нормальное поведение для igmp snooping ?
2. Второе что интересует это откуда берутся эти записи:
c3750x#sh ip igmp snooping group
Vlan Group Type Version Port List
-----------------------------------------------------------------------
1 224.0.1.24 igmp v2 Gi1/0/7
1 224.0.1.60 igmp v2 Gi1/0/7
1 224.0.2.60 igmp v2 Gi1/0/7
1 224.10.10.10 igmp v2 Gi1/0/5
1 226.100.10.15 igmp v2 Gi1/0/7
1 226.100.10.29 igmp v2 Gi1/0/7
1 226.100.10.31 igmp v2 Gi1/0/7
1 226.100.10.49 igmp v2 Gi1/0/7
1 226.100.10.56 igmp v2 Gi1/0/7
1 226.100.10.69 igmp v2 Gi1/0/7
1 233.89.188.1 igmp v2 Gi1/0/6, Gi1/0/8,
Gi1/0/9
1 239.0.0.250 igmp v2 Gi1/0/8
1 239.192.152.143 igmp v2 Gi1/0/6, Gi1/0/7,
Gi1/0/8
1 239.254.1.2 igmp v2 Gi1/0/9
1 239.255.67.250 igmp v2 Gi1/0/6, Gi1/0/7
1 239.255.255.100 igmp v1,v2 Gi1/0/6, Gi1/0/7,
Gi1/0/8, Gi1/0/9
1 239.255.255.177 igmp v2 Gi1/0/7
1 239.255.255.246 igmp v2 Gi1/0/7
1 239.255.255.250 igmp v2 Gi1/0/6, Gi1/0/7,
Gi1/0/8, Gi1/0/9
1 239.255.255.253 igmp v2 Gi1/0/7
1 239.255.255.254 igmp v2 Gi1/0/7
c3750x#sh ip igmp mem
Flags: A - aggregate, T - tracked
L - Local, S - static, V - virtual, R - Reported through v3
I - v3lite, U - Urd, M - SSM (S,G) channel
1,2,3 - The version of IGMP, the group is in
Channel/Group-Flags:
/ - Filtering entry (Exclude mode (S,G), Include mode (G))
Reporter:
<mac-or-ip-address> - last reporter if group is not explicitly tracked
<n>/<m> - <n> reporter in include mode, <m> reporter in exclude Channel/Group Reporter Uptime Exp. Flags Interface
*,233.89.188.1 172.16.1.58 04:30:11 02:23 2A Vl1
*,239.254.1.2 172.16.1.58 02:12:17 02:23 2A Vl1
*,239.192.152.143 172.16.0.52 04:30:11 02:54 2A Vl1
*,239.255.255.254 176.56.22.27 02:42:31 02:48 2A Vl1
*,239.255.255.253 176.56.22.27 04:30:11 02:47 2A Vl1
*,239.255.255.250 172.16.1.129 04:30:11 02:35 2A Vl1
*,239.0.0.250 172.16.2.2 04:30:11 02:33 2A Vl1
*,239.255.255.246 172.16.2.89 04:30:11 02:23 2A Vl1
*,239.255.255.177 172.16.0.193 02:33:02 02:23 2A Vl1
*,239.255.255.100 172.16.3.2 04:30:11 02:23 1A Vl1
*,224.10.10.10 172.16.1.76 02:38:12 02:46 2A Vl1
*,226.100.10.69 172.16.2.208 03:10:51 02:33 2A Vl1
*,239.255.67.250 172.16.1.129 04:30:11 02:39 2A Vl1
*,226.100.10.49 172.16.0.117 03:10:52 02:23 2A Vl1
*,226.100.10.56 172.16.0.117 02:57:47 02:23 2A Vl1
*,226.100.10.15 172.16.0.117 03:10:55 02:23 2A Vl1
*,226.100.10.31 172.16.2.208 02:57:47 02:39 2A Vl1
*,226.100.10.29 172.16.2.208 02:57:53 02:23 2A Vl1
*,224.0.2.60 172.16.0.117 02:08:25 02:23 2A Vl1
*,224.0.1.24 176.56.22.27 01:50:33 02:56 2A Vl1
*,224.0.1.60 176.56.22.27 04:30:11 02:47 2A Vl1
Кто это и откуда? И кстати адрес репортера для моей тестовой группы 224.10.10.10 стоит адрес не моей тестовой машины, а кого то из сети, хотя такого быть не может.
3. Как управлять потоком в таких условиях и почему коммутатор не воспринимает данный поток как мультикастовый?
c3750x#sh ip multicast int vlan 10
Vlan10 is up, line protocol is up
Internet address is 2.2.2.2/24
Multicast routing: enabled
Multicast switching: fast
Multicast packets in/out: 0/0
Multicast TTL threshold: 0
Multicast Tagswitching: disabled
c3750x#sh ip traff
IP statistics:
Rcvd: 42044197 total, 2284946 local destination
0 format errors, 1722248 checksum errors, 0 bad hop count
427 unknown protocol, 38037022 not a gateway
0 security failures, 0 bad options, 3109719 with options
Opts: 0 end, 0 nop, 0 basic security, 0 loose source route
0 timestamp, 0 extended security, 0 record route
0 stream ID, 0 strict source route, 3109719 alert, 0 cipso, 0 ump
0 other
Frags: 0 reassembled, 0 timeouts, 0 couldn't reassemble
0 fragmented, 0 couldn't fragment
Bcast: 1973326 received, 2 sent
Mcast: 280568 received, 2457 sent
Sent: 33636 generated, 0 forwarded
Drop: 14 encapsulation failed, 0 unresolved, 0 no adjacency
0 no route, 0 unicast RPF, 0 forced drop
0 options denied, 0 source IP address zeroICMP statistics:
Rcvd: 0 format errors, 0 checksum errors, 0 redirects, 5 unreachable
23 echo, 0 echo reply, 0 mask requests, 0 mask replies, 0 quench
0 parameter, 0 timestamp, 0 info request, 0 other
0 irdp solicitations, 0 irdp advertisements
Sent: 0 redirects, 4 unreachable, 5 echo, 23 echo reply
0 mask requests, 0 mask replies, 0 quench, 0 timestamp
0 info reply, 0 time exceeded, 0 parameter problem
0 irdp solicitations, 0 irdp advertisements
TCP statistics:
Rcvd: 31017 total, 0 checksum errors, 0 no port
Sent: 31136 total
EIGRP-IPv4 statistics:
Rcvd: 0 total
Sent: 0 total
PIMv2 statistics: Sent/Received
Total: 0/0, 0 checksum errors, 0 format errors
Registers: 0/0 (0 non-rp, 0 non-sm-group), Register Stops: 0/0, Hellos: 0/0
Join/Prunes: 0/0, Asserts: 0/0, grafts: 0/0
Bootstraps: 0/0, Candidate_RP_Advertisements: 0/0
Queue drops: 0
State-Refresh: 0/0
IGMP statistics: Sent/Received
Total: 2457/280568, Format errors: 0/0, Checksum errors: 0/0
Host Queries: 2457/0, Host Reports: 0/268009, Host Leaves: 0/6556
DVMRP: 0/0, PIM: 0/0
Queue drops: 0
UDP statistics:
Rcvd: 1972906 total, 0 checksum errors, 1705762 no port
Sent: 17 total, 0 forwarded broadcasts
OSPF statistics:
Last clearing of OSPF traffic counters never
Rcvd: 0 total, 0 checksum errors
0 hello, 0 database desc, 0 link state req
0 link state updates, 0 link state acks
Sent: 0 total
0 hello, 0 database desc, 0 link state req
0 link state updates, 0 link state acks
ARP statistics:
Rcvd: 10337749 requests, 671 replies, 0 reverse, 0 other
Sent: 85 requests, 478 replies (0 proxy), 0 reverse
Drop due to input queue full: 0
CheckSumm Error и Alert постоянно растут, почему тоже не знаю.
Приму любую помощь в понимании происходящего и в понимании того как этим потоком управлять. Заранее благодарен.