есть алата NM-HDV с 2-мя портами E-1, он раньше стоял на Cisco 2600, теперь я его хочу поставить на 3620.3620 Плату не видет!!! хотя должен, переставляю на 2600 все по прежднему функцианирует, в чем может быть проблема? думал мож с IOS-ом проблема?
TJK#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (C3620-IO3-M), Version 12.2(32), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Fri 02-Dec-05 15:48 by
Image text-base: 0x60008930, data-base: 0x60A88000
ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TJK uptime is 3 minutes
System returned to ROM by power-on
System image file is "flash:c3620-io3-mz.122-32"
cisco 3620 (R4700) processor (revision 0x81) with 59392K/6144K bytes of memory.
Processor board ID 18732010
R4700 CPU at 80Mhz, Implementation 33, Rev 1.0
Bridging software.
X.25 software, Version 3.0.0.
4 Ethernet/IEEE 802.3 interface(s)
DRAM configuration is 32 bits wide with parity disabled.
29K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102