4.6 Post-installation activities

After installing a new application you will normally want to read any documentation it may have included, edit any configuration files that are required, ensure that the application starts at boot time (if it is a daemon), and so on.

The exact steps you need to take to configure each application will obviously be different. However, if you have just installed a new application and are wondering ``What now?'' these tips might help:

• Use pkg_info(1) to find out which files were installed, and where they were installed to. For example, if you have just installed FooPackage version 1.0.0, then this command

      # pkg_info -L foopackage-1.0.0 | less
  

  will show all the files installed by the package. Pay special attention to files in man/ directories, which will be manual pages, etc/ directories, which will be configuration files, and doc/, which will be more comprehensive documentation.

  If you are not sure which version of the application was just installed, a command like this

      # pkg_info | grep foopackage
  

  will find all the installed packages that have foopackage in the package name. Replace foopackage in your commandline as necessary.

• Once you have identified where the application's manual pages have been installed, review them using man(1). Similarly, look over the sample configuration files, and any additional documentation that may have been provided.

• If the application has a web site, check it for additional documentation, frequently asked question files, and so forth. If you are not sure of the web site address it may be listed in the output from

      # pkg_info foopackage-1.0.0
  

  will often include a WWW: line with the URL of the application's web site.