6.10. timeout

This value is used to timeout the given command. The units of this value are milliseconds. The time being measured is from when a command is sent until when sg is informed the request has been completed. A following read() can take as long as the user likes. Timeouts are best avoided, especially if SCSI bus resets will adversely effect other devices on that SCSI bus. When the timeout expires, the SCSI mid level attempts error recovery. Error recovery completes when the first action in the following list is successful. Note that a more extreme measure is being taken at each step.

• the SCSI command that has timed out is aborted [1]

• a SCSI device reset is attempted

• a SCSI bus reset is attempted. Note this may have an adverse effect on other devices sharing that SCSI bus.

• a SCSI host (bus adapter) reset is attempted. This is an attempt to re-initialize the adapter card associated with the SCSI device that has the timed out command.

If all these fail then the device may be set "offline" which means that it is no longer accessible (except by this driver when open()-ed O_NONBLOCK) until the machine is rebooted. Offline devices still appear in the cat /proc/scsi/scsi listing. The last column of the cat /proc/scsi/sg/devices listing shows the online/offline status of a device ("1" means online while "0" is offline). The exact status returned depends on which level of error recovery succeeded. Most likely the 'host_status' will be set to DID_ABORT or DID_RESET.

The two error statuses containing the word "TIME(_)OUT" are typically _not_ related to a command timing out. DID_TIME_OUT in the 'host_status' usually means an (unexpected) device selection timeout. DRIVER_TIMEOUT in the 'driver_status' byte means the SCSI adapter is unable to control the devices on its SCSI bus (and has given up).

The type of timeout is unsigned int (and it represents milliseconds).