The OpenNET Project / Index page

[ новости /+++ | форум | теги | ]

Интерактивная система просмотра системных руководств (man-ов)

 ТемаНаборКатегория 
 
 [Cписок руководств | Печать]

smc91c92_cs (4)
  • >> smc91c92_cs (4) ( Linux man: Специальные файлы /dev/* )
  •  

    NAME

    smc91c92_cs - SMC 91cxx device driver
    

     

    SYNOPSIS

    insmod smc91c92_cs.o [pc_debug=n] [if_port=n] [irq_list=i,j,...]

     

    DESCRIPTION

    Smc91c92_cs is the low-level Card Services driver for SMC 91c92, 91c94, 91c96, and 91c100 based PC Card ethernet adapters. When this driver is attached to a card, it allocates the next available ethernet device (eth0..eth#). This device name will be reported in the kernel log file, and passed on to cardmgr(8).

    With the default transceiver setting, the driver will attempt to continuously autodetect the transceiver type (10base2 or 10baseT). There should normally only be a one or two second lag before the correct transceiver is selected. On particularly noisy or busy networks, it is possible for the detection logic to incorrectly toggle the transceiver type. If this becomes a problem, it may be necessary to explicitly select the interface type when the module is loaded or with the ifport command.

     

    PARAMETERS

    pc_debug=n
    Selects the PCMCIA debugging level. This parameter is only available if the module is compiled with debugging enabled. A non-zero value enables debugging.
    if_port=n
    Selects the transceiver type. 0 is autodetect (10baseT or 10base2), 1 is 10baseT (twisted pair), and 2 is 10base2 (BNC, or thin net). The default is 0 (autodetect).
    irq_list=i,j,...
    Specifies the set of interrupts that may be allocated by this driver.
     

    DIAGNOSTICS

    eth#: interrupt(s) dropped!
    Indicates that the driver did not receive an interrupt notification for some reason. The driver will poll the card (with a significant performance penalty) if the problem persists. The most likely cause is an interrupt conflict and/or host bridge configuration problem.

     

    DIAGNOSTICS

    eth#: interrupt(s) dropped!
    Indicates that the driver did not receive an interrupt notification for some reason. The driver will poll the card (with a significant performance penalty) if the problem persists. The most likely cause is an interrupt conflict and/or host bridge configuration problem.

     

    AUTHOR

    David Hinds - [email protected]

     

    SEE ALSO

    cardmgr(8), pcmcia(5), ifport(8).


     

    Index

    NAME
    SYNOPSIS
    DESCRIPTION
    PARAMETERS
    DIAGNOSTICS
    DIAGNOSTICS
    AUTHOR
    SEE ALSO


    Поиск по тексту MAN-ов: 




    Партнёры:
    PostgresPro
    Inferno Solutions
    Hosting by Hoster.ru
    Хостинг:

    Закладки на сайте
    Проследить за страницей
    Created 1996-2024 by Maxim Chirkov
    Добавить, Поддержать, Вебмастеру